CCS :: View topic - 24EP256GP202 polled I2C not seeing the start bit?

FAQ

Forum Help

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

24EP256GP202 polled I2C not seeing the start bit?
Goto page Previous 1, 2

CCS Forum Index -> General CCS C Discussion

View previous topic :: View next topic

Author

Message

allenhuffman

Joined: 17 Jun 2019
Posts: 617
Location: Des Moines, Iowa, USA

Posted: Fri Dec 20, 2024 7:35 pm

Ttelmah wrote:

Possibly sounds as if the timer interrupt was not exiting.
At least you have found it. Would be nice though to work out what it
really was about that interrupt causing the problem.

As soon as I get my firmware updater completed (the one I wrote in 2019 is unable to be built with the current .Net8 or whatever), I will do some tests loading a very simple program that tests the timer IRQs and such.

Should be interesting!
_________________
Allen C. Huffman, Sub-Etha Software (est. 1990) http://www.subethasoftware.com
Embedded C, Arduino, MSP430, ESP8266/32, BASIC Stamp and PIC24 programmer.
http://www.whywouldyouwanttodothat.com ?

Using: 24FJ256GA106, 24EP256GP202 and 24FJ64GA002.

Display posts from previous:

	CCS Forum Index -> General CCS C Discussion	All times are GMT - 6 Hours Goto page Previous 1, 2
Page 2 of 2

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum